Facebook
Google
GitHub
LinkedinSearch results
-
-
You may enter multiple names here.
-
GE mark vi problems
We are running GE mark vi, our gas turbine has been down for more than one year, we fixed it last week, we run the machine to full speed but the IGV did not, we try forcing the logic from mark VI but there was no respond. We have change the servo coil, still no respond. Please can somebody help...- EBUWAODUWA
- Thread
- Replies: 3
- Forum: Power Generation
-
88QA keep coming on when the turbine main lube oil pump is running
from what i understand, the GE gas turbine always have to submisiary pump to support the main pump. In our plant we have GE gas turbine, we have QA and QE. QA is the main lube oil and QE is the Auxiliary lube oil pump. before start up the QE comes up, after the machine is on full speed the main...- EBUWAODUWA
- Post #13
- Forum: Power Generation
-
Vibration Protection during Critical Speed ranges of Steam Turbine
I have a question, our wheelspace thermocouple is indicating Out of Range. we have done serious troubleshooting but still not working. We are planning to change the Thermocouple but where the device is located is very tight. My question is 1"What is the normal resistance for good wheelspace...- EBUWAODUWA
- Post #5
- Forum: General Software Chat
-
Ingersoll Rand Air Compressor machine.
We are having serious issue with our Ingersoll Rand Air Compressor machine. After delivery the required pressure the machine goes off, when the pressure is low,it doesn't come up on Auto. What could be the likely cause.- EBUWAODUWA
- Thread
- Replies: 5
- Forum: General Automation Chat
-
BEARING
What is thrust bearing and where it is located in GE gas turbine- EBUWAODUWA
- Thread
- Replies: 1
- Forum: Electrical Engineering
-
synchronization Failure
How do i troubleshoot synchronization failure? Our GE frame 9E gas turbine failed to synchronize, though the permissive is there but it can't synchronize. What should i do.- EBUWAODUWA
- Thread
- Replies: 3
- Forum: Sensors & Calibration
