Search results

It is a very good support for solving this case...

Hello ! You are welcome here! Do not hesitate to reach us for support! Always glad to support you ! James

Hi! I have read a CCC manual it is showing a "gains & biases chart" on DIFFERENT parameters like flow, pd ( abs ) pd (gauge) ... Plz have a good read on that OEM manual... there is also tranmitter span to take into account when calculating flow... I attach the document here so you can read...

Okay Aksm238 Thanks for clarifying the situation The original poster Aksm238, idea is to use RFG for HRSG duct burners/supplementary firing.... Not on GT combustion chamber.... Aksm238 got a original idea but the way it is presented is little bit chaotic.. But no problem I understood what...

OK where are you stuck... Configuring Proface and other devices should not be a problem

Me think that you should use 2wire type connection using terminal block of the type "potentiel distributor".. Refer to page 13/14 of OEM manual It is well described how to connecy/wire such sensor. Glad to help you! James

Thats why I mentionned/asked on my last post ,if there was supplementary firing see following elements below : Have a study on the FCP (fuel charged to Power) ...there is formula explained on OEM GER-3574G document , and other inetresting informations regarding fuel consumption ...

Hello Thanks for your inputs ! Have a read on that website article it is very useful for this case... https://blog.pepperl-fuchs.us/how-to-wire-a-proximity-sensor-to-a-plc You got also kind of module interface like this one below...

Do you confirm that communication between Flex6 nano and other devices is done through ethercat or ethernet.. Did you check compatility/support by proface in this case...

Or maybe fail safe philosophy should be applied on this case...

Hello WalterCTPL2019 Hum you "modified a existing rung " right? I am waiting for the input on that 59B functionnality/origin...to add comments.. Plz tell us origin of the contact and is relationship to PSS... There could be mismatch somewhere in the loop! or other origin on this issue... Do...

By the way , can you tell us what 59B stand for ( is that for Overvoltage protection) or .. ....

When new segment is created , it shoudl be adde to MSTR_SEQ.CFG Is that been done in this case... James

Hello ! My first question would be ...did you used /performed Sequence compiler ( by entering COMP_SEQ command...at teh command line ) of the unit specific directory .... Thanks for clarifying.. James

Glad to see that my effort can be a positive feedback for your guys& woman (of course)!

Hi RomanM94, Indeed it is a great and useful information that can give you good supports /tips .. Do not hesitate to share your feedback! James.

Check ALSO PROFIBUS "itself " warning code according to OEM Manual...

Warning 34 won't hurt anything. It usually comes up during startup, if the VFD has an communications option card (bacnet) and no communications connected. After a couple of minutes without communications, you will get "Fieldbus Fault W34", a comm failure on the card. It has no effect on the...

Hi Thanks for the inputs/tips Here what i found on that similar issue: https://www.incontrolhvac.com/blog/2016/8/10/danfoss-warning-34-communication-failure Hope it can highlight you on the reason ! Always glad to support ! James

ridge poller slave103aholding [ start=32009, length=1, refresh=10000, type="holding" ]{ Thing data Alarm_2bit0 [ readStart="32009.0", readValueType="bit",updateUnchangedValuesEveryMillis="5000000" ] Thing data Alarm_2bit1...