Search results

The VLAN switch has been tested, infact taken to another GT and it is working perfectly. The orange and green light on the UCVE card were ON , infact the orange light is blinking and another Ethernet cable was used to test one of the rack by disconnect the existing ones. Although we are trying...

Thank you very much. Each of the UCVE card has Flash memory (SD memory) card and when we are installing the new UCVE card we replaced SD memory according to each of the Rack R S and T respectively . The voltage of CMOS battery is 3Volts D.C. and some can be 3.3Volt or 3.5 but it cannot be more...

The net start tci had been invoked from cmd, and status remain the same because the connection cannot be established to the controller

Thank you WTP, so far we have done ping test so as to establish connection to the three controllers from the computer but it was not successful, physically,on UCVE the orange light is seen blinking while the green light is also ON which shows connection with the switch. As for the CMOS battery...

Thank very much sir, Please can you send the copy of GEH- 403L to me because I've trying to search for it which I couldn't.. My e-mail add: [email protected]. Thank you and God bless

Tha

Thank you very much, the booting was normal after we were able to Recycle power on Mark VI after we check VCMI card on Rack T and the IONET cable

Thank you, How do I identify the battery that has problem from the three controller (UCVE) of R,S,T rack. Is it by testing the voltage of the battery on after the othet

The unit has conventional combustion system and not DLN machine

The Good day. The rating if the generator is 42MW and 50MVA Thank you very much. The control aspect has been checked, the Value of CPD, the value obtained from 96CS was also look into, the ambient and exhaust temperature was also carefully look into. The quality of the fuel is the same as...

Good day There is no process or diagnostic alarms displayed..The following are major components changed during the maintenance period. Turbine buckets(1st Stage, 2nd Stage and 3rd Stage). Turbine Nozzle (1st Stage, 2nd Stage and 3rd Stage). Transition Pieces. The Compressor was brought out and...

Good day. The ambient air temperature is the same, there is no difference. Then the system parameters was not changed during the maintenance period.The air inlet filter has been changed after the incidence. Although, the load transducer has not been calibrated because we think that the two...

Thanks. Slightly is about 3 to Megawatt. The MI maintenance job was contracted out to company. We have eight GTs on site with the same capacity and ratings and one of the machine was given out for MI.

Please send me manual and drawing for torque converter. [email protected]

I'm yet to look into that document Meanwhile, there is no alarm on the HMI to that effect and UCVE card that was changed is on S- Rack, But I think other two Racks were okay i.e UCVE card for R rack which is designated controller and that of T rack are still intact and okay. In my opinion, I...