Recent content by dustin

Hi , the old machine was pentium III.

Hi, am facing a problem. My IDOS machine is out of service. I reused the hard drive and the Arcnet ISA card in a new Pentium II machine, but I get a yellow error message when I start the application. Please help. I suspect the memory... The new machine has 32 MB. The arcnet.dat file is...

Hi all , I dont know if i succeed , in the bios , i changed this option D000 32 K SHADOW from disabled to enabled and the yellow message gone , and the arcwho start scanning the network . i hope yhis can be helpful thanks for you all .

thanks again. first the arcnet card is configured as the same one that is working perfectly . my question : 2F SHOWn IN ARCNET.dat is the adress of mark v.so i have to avoid this adress with the dip swiths?. the yellow message can disapper if i succed to configure the arcnet card without connect...

Hi all , Thanks for replaying , here you will find the jumpers sets in the arcnet .typing arcwho nothing .... Thanks

Hi all , Thanks for your help . I attached the file that contains error releted to arcnet . Thanks .

hi all yes i attempt to add an old machine to existing arcnet network .

Hi all , Thanks for your help. i was able to clone a working idos hdd . the cloned hdd boots successfuly on an old machine and i can see the old hmi and access to program. Cause i am curious , i added the arcnet card in isa slot , i know the irq of the arcnet is 15 but no communication with the...

Dear sir , Thanks for your help . what about this : what you say here , is good for me : **** Anyway, I think you could probably take the <I> (IDOS) hard drive, put it in a machine with IDE capability as a non-primary disk, and then use Acronis or something similar to duplicate the drive to...

Hi , Thanks for you replay , My goal is not to clone hdd an run it on an old pc to communicate with mark V . my boss will give me an hdd taken from a machine ( Old machine ) that is running acutually and communication with mark v. turbine. i have a P4 machine : Win 98 to clone the hdd i have...

Hi , thanks for you all , my english is not good so .... we want to upgrade existing mark v to new HMI hardware , but before i want to clone the existing hdd and send it to our engeeneer . i am familiar with old msdos 3.xx 6.xxx , fat 16 ...fdisk ..... i prepared an old machine P4 with isa...