I’m attaching images of the parts required to build a pc for programming the older Bosch PLC units.
I think I also have a manual in pdf format that will help you.

The images show you the dongle(parallel port connection), connection cable and SPS card.

It not difficult to find an old pentium system that will accommodate the ISA connection of the SPS card.
I’m sending an image of my "portable" home made unit, that still works. It must must be 30 years old now.
I think I also have a programming manual in pdf that I will look for.

Regards

Hello,

Thank you for your explanation. It is very useful.
I have just a question: Is it necessary con install any kind of driver on the PC where the SPS card have been installed?
Thank you

 

I have a PG4, and I have an input file for PLC PC600. I managed to compile (liniking) the input file without errors.

I connected the PG4 to a PC600 card via a K8 cable.

I have a RAM-based controller without eProm. Unfortunately, when I try to load or turn on the monitor in PG, I get a communication error.

Which slot should I insert the P600 card into?
How do I prepare the PLC for communication and downloading?
How supost be sets key on Edit?

Does anyone have step-by-step instructions? Does anyone have the user manual?