Search results

Hi Here is what i found on the update rate for such equipment... Is that something similar that you are looking for

Can you share here a quick update on the issue that you've been facing at your site....

Ok thank you for let us know the status of this issue..

I advise you to check the behavior of the CONTROLLER MONITOR BLOCK in the APP CODE at your site... There is an input called ONLINE FL TMR check what is the adjusted value ... Other wise better troubleshoot why you get that Alarm befor to get the unit online as you may run this unit as DUPLEX...

Hello Looks like the G2.L30CSHB_Q_ALM: CONTROLLER HEARTBEAT is displayed when one of the three Controller (R/S/T) is not online according to the app code taht i got. Is that the case ...I mean is that R controller is not "online"...

Hello Ahmad Mob Even seems that this thread is bit old can you update on the issue you vee been facing at your site... We may help you from here...

Hello Mr Laid, Can you update here on that issue you ve been facing Regards, Controlsguy25

Hi Ok nice to meet you here! Well i see that there is kind of help assistant from DOS command as per this screenschot: View GSM Software seems to be poor documented ...i will look closer on from documenation that i got ..

VIEW2 – VIEW POINTS FROM A CONTROLLER, HIGH SPEED BUFFERED This establishes a high speed (up to 32 Hz) list of points with one controller in one unit. The resulting data is buffered in memory, then flushed to a disk file when done collecting. VIEW2T – VIEW2 DATA WITH PRE/POST TRIGGER...

Dear Here is what i foundon View2 : TILITIES ASSOCIATED WITH VIEW*.EXE OUTPUT FILES VIEW2CSV.EXE: Format a VIEW2 file for direct (CSV) import into EXCEL. VST2CVS.EXE: Format a VIEWST.OUT file for direct (CSV) import into EXCEL. T2XLS20.EXE: Converts View files to EXCEL files. NOTE...

Also GEI-100829

Dear Azelio, Are you referring to <I DOS> or HMI .. Are you referring to the standard communication protocol between HMI OR I DOS MARKV with a DCS? By the way you can have a search and a look on GEI-100658 AND GEI-100516

I got a GE specification/docuemntation saying that the unit should be on cooling mode for 24 hours (minimun after shutdown) Also GE recommand the unit turning /crank cooling continue for 48 hours to ensure uniform rotor cooling . Will have a closer look on that subject on teh documentation...

Hi What is the status of the issue you ve been facing aqt your site... Do you have any improvement... With a quick update we can provide a better support

Good day Mr Sharama, Can you give a quick update on the issue you ve been facing... We can support in case this issue is still pending /not solved.. Regards, Controlsguy25

Dear Amar, You can also check if you getting any alarm message so we can have a better troubleshooting form here... Regards, James

Dear Amar, Thank you for these informations .. Did you try that P8.5 test sequence ...during commissioning..