Search results

You may enter multiple names here.
  1. G

    Printer in Free Port Mode with S7-200

    Hello, S7-200 is installed with dot matrix printer. its printer is not working now I have changed the printer. problem in new printer is its print direction. it is printing in forward direction. I want to change it to reverse. i have changed the print direction of the printer by its setting...
  2. G

    CAREL Vision 2020i Communication with HMI

    Dear All, can I connect Carel Vision 2020i controller with Siemens/Weintek/Delta etc HMI directly? If not then what is the option to connect Vision 2020i controller with an HMI (Siemens/Delta or Weintek) waiting for reply Thanks
  3. G

    Hydraulic proportional Valve Controlling

    Dear All, I want to automate a vertical injection molding machine. Currently PORCHESON PS660BM was installed. Now I am going to replace it with DELTA PLC. I am confused how to control proportional valves EFGB-03-125-C-20 & EDG-01-C-20 According to datasheets of the valves, its rated mA are 800...
  4. G

    VFD- Input amperes are greater than Output

    1. Yes, amps on all 3 phases are same 2. on 60Hz, input amps are 90A and output amps are 73A 3. No 4. I don't have power meter 5. output amps are of 75% of VFD rated capacity waiting
  5. G

    VFD- Input amperes are greater than Output

    Using normal clamp meter. And this meter is working fine with other drives
  6. G

    VFD- Input amperes are greater than Output

    Our VFD is 3 phase 380V Amps on input side are higher than output
  7. G

    VFD- Input amperes are greater than Output

    Dear All, Normally we see that on a VFD, input side amperes are less than output side amperes but here in one case, input amps are more than output amps can anyone tell me what may be the reason? waiting
  8. G

    Emerson Micro Motion CNG050 Modbus Problem

    I have tried by accessing 0247/0248 for mass flow rate but when I use these addresses then HMI shows address error. these are the readings on software. when I access mass inventory and volume inventory then the HMI showing address error. what should I do?
  9. G

    Emerson Micro Motion CNG050 Modbus Problem

    Dear All, I want to connect HMI with Emerson micro motion to display some parameters link mass flow rate, mass inventory , volume inventory etc. Address for these registers given in manual are 20247/20248, 20263/20264, 20265/20266. But when I enter these addresses in HMI, then it shows...
Top