Hi All

I am writing this thread , to try to get informations on a procedure "how to calibrate LVDTs feedback signals" specially what signals names to get forced ..with Mark6e"

Thank you for your reply

James

 

Hi All

I am writing this thread , to try to get informations on a procedure "how to calibrate LVDTs feedback signals" specially what signals names to get forced ..with Mark6e"

Thank you for your reply

James

Solution found finally...

 

@ControlsGuy25,

You gave no hint what machine you were working (LM; HDGT; ST; etc.) OR the age of the machine. OR if the machine uses electric actuators for control valves/IGVs or hydraulic actuators. And, some of the newest machines use different signal naming schemes so we would also be guessing at signal names without being able to see P&IDs and/or application code.

You might also have been asking about logic signals enabling LVDT calibration--but you gave no clue about that either.

Glad you found what you were looking for (because we had no idea what you were looking for). GE Belfort probably doesn't write machine-specific LVDT calibration procedures for the machines they have responsibility for--but if they do/did, that is good news if they truly are machine-specific and not generic.

 

@WTF

Sorry you are right , I did not mention unit frame /model

Well it is for LM2500 commissioning ...

I was looking for logic signals name to force for doing such work ..

I finally refound a file used for Frame9FB

I don't have yet app code so cannot tell more about ..

Thank you for your attention and reply

Regards,
@ControlsGuy25