Facebook
Google
GitHub
Linkedin
Dear Sir/Madam,
I hope this message finds you well. I am currently a university student pursuing a degree in Control and Automation Engineering. I would like to seek advice from experienced professional engineers, or those who have at least had practical experience in this field, regarding a book titled "Electric Circuits," 10th edition, by James W. Nilsson and Susan Riedel. The contents of the book’s chapters are as follows:
1. Circuit Variables
2. Circuit Elements
3. Simple Resistive Circuits
4. Techniques of Circuit Analysis
5. The Operational Amplifier
6. Inductance, Capacitance, and Mutual Inductance
7. Response of First-Order RL and RC Circuits
8. Natural and Step Responses of RLC Circuits
9. Sinusoidal Steady-State Analysis
10. Sinusoidal Steady-State Power Calculations
11. Balanced Three-Phase Circuits
12. Introduction to the Laplace Transform
13. The Laplace Transform in Circuit Analysis
14. Introduction to Frequency Selective Circuits
15. Active Filter Circuits
16. Fourier Series
17. The Fourier Transform
18. Two-Point Circuits
My question is: Do I need to learn all the material from every chapter of this book in order to perform the tasks of a Control and Automation Engineer? Additionally, what steps should I take in my learning journey?
I sincerely appreciate any guidance or suggestions you can provide.
I hope this message finds you well. I am currently a university student pursuing a degree in Control and Automation Engineering. I would like to seek advice from experienced professional engineers, or those who have at least had practical experience in this field, regarding a book titled "Electric Circuits," 10th edition, by James W. Nilsson and Susan Riedel. The contents of the book’s chapters are as follows:
1. Circuit Variables
2. Circuit Elements
3. Simple Resistive Circuits
4. Techniques of Circuit Analysis
5. The Operational Amplifier
6. Inductance, Capacitance, and Mutual Inductance
7. Response of First-Order RL and RC Circuits
8. Natural and Step Responses of RLC Circuits
9. Sinusoidal Steady-State Analysis
10. Sinusoidal Steady-State Power Calculations
11. Balanced Three-Phase Circuits
12. Introduction to the Laplace Transform
13. The Laplace Transform in Circuit Analysis
14. Introduction to Frequency Selective Circuits
15. Active Filter Circuits
16. Fourier Series
17. The Fourier Transform
18. Two-Point Circuits
My question is: Do I need to learn all the material from every chapter of this book in order to perform the tasks of a Control and Automation Engineer? Additionally, what steps should I take in my learning journey?
I sincerely appreciate any guidance or suggestions you can provide.
