J
Hi listers,
I have a little electrical problem.
I have sensors which output is in 4-20mA. My acquisition board accepts only 0-10V.
What is the better way to trasform 4-20mA signal in voltage.
I think a 500 ohms resistor is not sufficient to give me a clean signal. What I have to add to this signal ?
I have the similar problem with an encoder which gives me a 24V output. I would like share it to several PLCs, but the signal will decrease according to the number of PLCs.
I have another application where I have an encoder (24V) and my counter board accepts only TTL signal. What do I have to apply to this signal in order to keep clean signals?
thank you for your help
Jeff
[email protected]
SoViLor company
I have a little electrical problem.
I have sensors which output is in 4-20mA. My acquisition board accepts only 0-10V.
What is the better way to trasform 4-20mA signal in voltage.
I think a 500 ohms resistor is not sufficient to give me a clean signal. What I have to add to this signal ?
I have the similar problem with an encoder which gives me a 24V output. I would like share it to several PLCs, but the signal will decrease according to the number of PLCs.
I have another application where I have an encoder (24V) and my counter board accepts only TTL signal. What do I have to apply to this signal in order to keep clean signals?
thank you for your help
Jeff
[email protected]
SoViLor company