Hello,

I have problems with OP15A panel (project of 1994). I want to upload this project from OP15A to PC. There is COMTEXT software installed on PC. PC is linked to OP by TTY interface. OP is switch on and COMTEXT mode is selected there. I select menu Transfer in the COMTEXT, then select item TDOP --> FD and press F1 key (start).

The messages:
$006 COM-Transfer fail - No: 0 Sts:5
$006 COM-Transfer fail - No: 0 Sts:10
$006 COM-Transfer fail - No: 2 Sts:3
is appeared periodically.

Thanks in advance.

 

There is an upload feature, but I don't believe it is equivalent to the upload in a PLC in terms of recovering the complete program. If you don't have the original Comtext program then you are out of luck and have to write it over again.