GE OC6000e and GE RX3i Communication


Thread Starter


Hello guys,

I would like to know if it's possible to communicate or exchange data between OC6000e and GE RX3i PLC?

The network connection between these 2 platform is Ethernet. Do I need to add comms module for RX3i to be able to send/receive data from OC6000e (or vice versa)? Who will initiate read/write command?
It would depend first on the communications protocol your equipment uses.

I believe at this point all Ethernet RX3i CPUs speak native Modbus TCP and EGD.