F
I require information about address the controller Digitric 500, manufacturing ABB Control System.
There is one a distillation column, controlled by two DIGITRIC 500, (manufacturing ABB); they have connected sensors of temperature, flow, etc. However I would like to know; Where it is stored the data of each sensor?. In the document "MODBUS Interface Description 42/62-50040 EN", it specifies the registers of parameters.
i.e: APPENDIX 1: MODBUS register table of global variables REAL, INT, DINT, LONG
REGISTER: 4, DATA TYPE real; DESCRIPTION: Slot 1 analogic input 1.
But with the protocol MODBUS, Which it is their real physical address?, if the data use the format IEEE (32 bits) are save in 2 registers.
There is one a distillation column, controlled by two DIGITRIC 500, (manufacturing ABB); they have connected sensors of temperature, flow, etc. However I would like to know; Where it is stored the data of each sensor?. In the document "MODBUS Interface Description 42/62-50040 EN", it specifies the registers of parameters.
i.e: APPENDIX 1: MODBUS register table of global variables REAL, INT, DINT, LONG
REGISTER: 4, DATA TYPE real; DESCRIPTION: Slot 1 analogic input 1.
But with the protocol MODBUS, Which it is their real physical address?, if the data use the format IEEE (32 bits) are save in 2 registers.