D
Dear List,
Simple opinion of course or if there are legislative rules regarding this matter I would greatly appreciate those references. A VFD lead wire is to be spliced. Why because it is cheaper, and yes a point of failure. Now to marrett and tape or splice in a junction panel? To locate the splice some where in a wire trough at the ceiling or on a terminal block in a panel is the choice. My reasoning for the panel is so in time when it does loosen or need to be checked, access and location is defined, not some where between here and there. I invite experience comments and those interpretting rules of reference someone may have.
Dave van Rhijn
Simple opinion of course or if there are legislative rules regarding this matter I would greatly appreciate those references. A VFD lead wire is to be spliced. Why because it is cheaper, and yes a point of failure. Now to marrett and tape or splice in a junction panel? To locate the splice some where in a wire trough at the ceiling or on a terminal block in a panel is the choice. My reasoning for the panel is so in time when it does loosen or need to be checked, access and location is defined, not some where between here and there. I invite experience comments and those interpretting rules of reference someone may have.
Dave van Rhijn