Hello everyone,
I'm working on a project where I'm using Vtscada Light to communicate with a MicroLogix 1200 PLC. Currently, I can read values from the PLC without any issues. However, I'm facing difficulties when attempting to write values back to the PLC.
Setup:
I'm looking for guidance on the proper method to write values to the. If anyone has experience with this setup or similar, your insights would be much appreciated.
Thank you for your help!
I'm working on a project where I'm using Vtscada Light to communicate with a MicroLogix 1200 PLC. Currently, I can read values from the PLC without any issues. However, I'm facing difficulties when attempting to write values back to the PLC.
Setup:
- PLC: MicroLogix 1200
- SCADA Software: Vtscada Light
- Communication: Rockwell Driver with a serial port and serial-to-ethernet converter
I'm looking for guidance on the proper method to write values to the. If anyone has experience with this setup or similar, your insights would be much appreciated.
Thank you for your help!
