Profibus Networking problem in Micromaster 3

S

Thread Starter

Sajjad Idrees

I am trying to configure vfd (Micromaster 3) through cb15 to cp342-5 and having a cpu 314IFM. I have set all the parameters of drive and I think it is communicating a bit but when I see module information it shows in profibus nodes (one active for master and one passive for slave node). But when I click on DP slave than it shows that DP slave is known and some of the check boxes are showing (station not ready. slave deactivated etc).

I think I am doing any mistake in hardware configuration.
 
Top