Try to find the correct setting for DCOM for Honeywell HCI OPC server.
I am looking for setting in server and in client application running on 2 different machines.

 

Take a look at MS's note on using DCOMCNFG;

http://support.microsoft.com/defaul...port/kb/articles/Q268/5/50.asp&NoWebContent=1

Microsoft Knowledge Base Article - 268550 HOW TO: Use Dcomcnfg for a Visual Basic DCOM Client/Server Application

My .02 worth on setting up DCOM (besides avoiding it) is listed below.

Use the Default Security tab and "Edit Default" for all three default; access permissions, default launch permissions, default config permissions.

Make sure you give all the users (Administrator, local, etc) rights to allow, full control and etc.