Search results

As per OEM manual Droop calibration contains " No load calibration " & "Full load calibration"..

I suspect Droop calibration/tuning procedure not correct We can see that "Actuator FS =131%" is that value ok for you...

Try to make "Chart view " BY USING PST...see what happening during these transients mode...

Thanks @Lee Tons Just a first obesrvation on the screenshot that droop percent showing value=0 Is that ok for you...

OEM/MODEL MAKER/MANUAFACTURER...

Well ..Apparently That site experienced serious problem ...a quick feedback from @Makster Would be welcome

Are you using PST or User interface ... Are you sure about Torque limit parameter adjustement How about frequency ...during that transient modes... Any alarm annuciated..

I gave some good contact link (se e my post ) for solving that serious problem that you got... A quick update woudl be welcome...

Thank you @Lee Tons for these hilights/inputs.. Still we do not know about Control scheme used ..and if PMS is installed/used .. Did you follow carefully OEM instructions...I have read one manual talking about droop calibration procedure...and other parameters tuning ... Can you post Governor...

Thanks for the Thanks for the imputs..

What alarm message /code annunciated..

Hi As this is Valmet DNA CONTROLS systems ( more applicated to DCS usually...) Can you tell us which procedure are you using ...to achieve correct operation...in order to get that LVDT feedbcak correct.. Are you sure about 65GC operation ...and servo regulator configuration/setting...

OK Thx for updating.. Cheers..

Thank you @Lee Tons for these inputs/highlights... We still do not know about control scheme used... So it seems that there are more than one generator.. Droop or isochronous mode.. Which one is selected... Is there kind of PMS installed ... Looking forward to hear back from you soon

Hi Can you give a quick update/feedback on my post as it required some time and effort..

Hi Can you give a quick update /feedback on my last post ...

We need to know what operating mode is used... Droop /isochronous.. Is that unit in commissioning... Looks like the control system may be not tuned /configured correctly... By replying to these questions.. We can then advise on how to get the issue fixed..

Hi Can you tell us what is that "Prot cap clsd " Means ... Thx Controlsguy25.

https://instrumentationtools.com/multiple-pumps-control-using-plc/

Can you tell us what you at least attending to do with such manipulation.. As There should be a "Lube oil test sequence " implemented.... Did you investigate on this side... I can provide more gathering datas for performing such operations...