Search results

Also at a speed of 82% (TNHCOR) the IGV should be opened from 34DGA to 57DGA is that this case it is showing THE IGVs are opened till 51.8DGA can you confirm...

..Can you share a CSP file with that TNK14HS1 rungs..

Thank you CSA for sharing ! Stay safe& Healthy! James

Hi All Taki27, Can you share screenshots taht you mentionned ... We Would be glad to support remotely.. James

I knew that it was exactly what you were looking as i wrote it on my last post! And I am very gald to see that you satisfied with my support here at least! Do not hesitate to share your achievements /works on that case... Thank you for sharing such case on this great forum! Any time ! do...

You will see that there is Map test mode to enable for Constants /parameters checking ... This manual is just good to read for this case..

So i don know if you got the right Manual ... and if yes did you have read the pages I mentionned ... Thanks for updating ..

Hi Fooke, I got answers for your questions.. What you are looking for is at page 128/129 of volume 2 presuming that you got an extraction ST... Can you tell us type of Steam turbine process..

I am not sure I use to see -10VDC for Gap voltage Can you answer on my last post ..which type you got ..7200 CAN be 5/8/14mm

Proximitor 7200 CAN BE 5/8/14 mm which one you have installed on this unit...

I have some answers to your questions: Have a read and carreful read ! on this document as all is well described and can respond to your questions about cable Extension (not extention) Looks like there is complete intercompatibility betweens probes /sensors & cables There is also "How to order...

Ok so you were speaking about "oscillator output offset voltage -12VDC" for simulating eddy current ...

I found the procedure very simple and quite explained ..on the OEM manual...

Do you mean Offset is 12 mV not 12V can you reread your post ...

Hello Do you have any OEM instrumentation list /setting sheet.. Also what is vibration level during these phases that you are referring...

Hi Fooke, Thank you for your reply.. Well I had a careful read on the 505e manual.. Looks like you will need to use service blocks modes to read K constants entered values in the installed controller.. Have a read on 505emanual vol2.. From page 97 to page 105...thats well described how to...

Actualy you were talking about Driver sheet ...I dont see worksheet ..can you confirm Have a carefully read on this video(35 min ) It contains communication configuration nbetween SCADA indusoft with S7..PLC Any time! James

https://docplayer.net/49958609-Modbus-communication-with-indusoft-scada.html

What type of protocol is used ...