Search results

Thanks for clarifying your questions Here some answers/notes : 1.The dead band filter cause the controller to ignore small in the turbine speed...SUCH AS +/-0.5% FROM speed setpoint ( depending on your application code settings of course) 2.I will have a look on Lower band vs Dead band...

Each prime mover's governor (control system) will respond to a change of frequency as a function of the amount of droop that the control system is programmed to have. A 1% change in frequency on a machine with 5% droop will result a 20% change in load, nominally, supposing the machine was...

Ok you asking a question but no "? " .... Kindly highlight your question by adding "?" It not a big deal i know but people like to read clear post...

Is there any question/issue that you are facing with.... Or this post is "just for information"

Ok so have a good read on OEM technical manual! it help

How about the issue... You facing with... Is there any error message returned... Did you follow OEM procedure/manual

Are you referring to PWM or other control method ... As the below article is referring to that control mode +24V PWM according to OEM manual, plz have a read on that one: https://www.plctalk.net/qanda/showthread.php?t=123152 James

Maybe There could be a solution with such card lets see what OEM offering on that product configuration with stepper motor motion control... I will be back then here to add some notes James

You better have a look on a motion control module interface for such applications .. Have a search on the web.. there are bunch of good documents to achieve such operations

So looks like it is a Thermistor that you got ? Right or RTD s Pleae clarify by adding more details... Here some notes for the Thermistor: How Accurate is the Reading? You may notice that above, the temperature reading is 28.16°C - does that mean we have 0.01°C accuracy? Unfortunately no! The...

Whitout be able to get the scheamtic showing RTD interface board also ...I cannot state more on what happening on your RTDs reading values... May we see any drawing/sketch of the mentionned subject...

Hello Did you hear aboout RTD lead wire compenstion * here some notes about it: Lead Wire Resistance RTDs are resistive devices, so lead wire resistance directly affects its accuracy.The error can be quite large, depending on the lead wire resistance (measured in ohms / foot).For example...

Hi Gsharma611 Is that HART 2870 INTERFACE MODULE that you are referring too ... Yes right, I know that there is MUX 2071 HART MODULE integrated with. 98356-10 Panel..you may have to investigate on this path ! It can be the source of issue as you stated , but you still didnot tell me about...

Hello it is possible , here some notes from OEMs manuals : • 4.2 Determining the Process Image of the WAGO node The figure below illustrates the hardware of the WAGO node in this example. The process image table (I/O map) is displayed in byte format below the figure. In order...

Hai Tarsyanraj, Glad to see that these notes are helpful to understand soak time with Hrsg. Regards James

Hi Can you be more specific /explicit About what you intending for ...what you mean for simulation with LONworks Looks like you need ressource files (.xif extension) You can download it from Danfoss website Also what is OEM reference number of the VFD... There is good OEM technicals...

Hello Are you referring to "Cool down " procedure/protocol on Combined cycle power plant.... Thank you for clarifying James

Hello , Did you have a look on similar case/threads here.... Sounds like now you got problem with both/dual fuel machine operations... Did you try to monitoring various signal/trendS RELATED/During to this "failed satrt up"? James

Hi Gsharma611, Thank you for your reply! Well did you have check the Hart module interface ...see if configuration is correct.. Or any other AO module interface like panel wiring ...as per OEM manual James James

Hello Without be able to check the wiring diagram or interconnecting diagrams , it is difficult to give you an answer.. Each site got is own as built drawings ! James