M
Hi Everybody,
I need to analyze dynamic data that I obtain from a generator. For example the actuator signal, speed signal, load signal etc.
To accomplish this I want to make a device that has 5 analog inputs. Via my Laptop I collect the data that I read from the inputs. I will use VB to accomplished this After that I present tham graphically. Is this the best way to do this?
Where can I go to get those interface cards? Eventually where can I go to get those softwares.
Your suggestions and advice are welcome.
thx
Mike
I need to analyze dynamic data that I obtain from a generator. For example the actuator signal, speed signal, load signal etc.
To accomplish this I want to make a device that has 5 analog inputs. Via my Laptop I collect the data that I read from the inputs. I will use VB to accomplished this After that I present tham graphically. Is this the best way to do this?
Where can I go to get those interface cards? Eventually where can I go to get those softwares.
Your suggestions and advice are welcome.
thx
Mike