V
Greetings!
I am trying to establish communication between DISOMAT Tersus and PC. The communication interface is RS-232. I am using Tersus interface S1 with the following configuration:
<i>Physics: RS232;
Baud rate: 9600;
Handshake: Off;
Data: 8bit no;
Stop bits: 1.</i>
In Tersus manuals I've found the information that connection with PC is provided via EDP option (Electronic Data Processing). The configurations for EDP are listed below:
<i>Scales: 1 (not sure is it correct);
EDP Interface: S1;
Protocol: MINPROZ (I need protocol without any acknowledgment, does this suits best?);
Data block: 0;
Decimal point: Dot (.);
Compatible: Tersus.</i>
I was guided by Tersus manuals during executing configurations. While testing the communication, I've tried different EDP request commands in different formats, but unfortunately, I still cannot receive any response from Tersus. It seems like connection have never been really established.
Can you please help me with configuration? What am I doing wrong or what I've missed? Any kind of help or reply will be greatly appreciated!
P.S. Please excuse me for my incompetence.
Best regards,
Vitaliy
I am trying to establish communication between DISOMAT Tersus and PC. The communication interface is RS-232. I am using Tersus interface S1 with the following configuration:
<i>Physics: RS232;
Baud rate: 9600;
Handshake: Off;
Data: 8bit no;
Stop bits: 1.</i>
In Tersus manuals I've found the information that connection with PC is provided via EDP option (Electronic Data Processing). The configurations for EDP are listed below:
<i>Scales: 1 (not sure is it correct);
EDP Interface: S1;
Protocol: MINPROZ (I need protocol without any acknowledgment, does this suits best?);
Data block: 0;
Decimal point: Dot (.);
Compatible: Tersus.</i>
I was guided by Tersus manuals during executing configurations. While testing the communication, I've tried different EDP request commands in different formats, but unfortunately, I still cannot receive any response from Tersus. It seems like connection have never been really established.
Can you please help me with configuration? What am I doing wrong or what I've missed? Any kind of help or reply will be greatly appreciated!
P.S. Please excuse me for my incompetence.
Best regards,
Vitaliy
