Control Codes via RS232


Thread Starter


I have a running application I'm not allowed to touch but I also have a little program called 'Wedge'. Wedge sits reading COM1 and writes any data received to the cursor position in the PC's current running program (used for scanners). I can control the cursor with TAB CR etc but I'm left with having to send "F3" (extended ASCII 00,61) and "Cntl-S" (ASCII 19) (save). I will be using an AB Basic module to program, format and send the data stream.
Has anybody done this or anything similar or have any ideas?
Thanks in advance,