Gentlemen,

How to communicate Danload 6000 with MODBUS RTU protocol?

Is the addressing type for Danload 6000 four, five or six digits?

How about the bit base? Zero to fifteen, one to sixteen, fifteen to zero or sixteen to one?

Where do I find the memory map for Danload 6000 using MODBUS RTU protocol communication?

Does anyone have Setup 6000 version 5x to configure Danload 6000? If so send it to me please.

Please help me.

Thanks,

Adriano Macário.

 

The Danload protocol is not standard Modbus RTU. It uses Modbus RTU message framing but will require a special driver or protocol converter
to communicate with it. We manufacture such a device. See our Omnii-Comm product at "http://www.miille.com/din266-p00.pdf":http://www.miille.com/din266-p00.pdf . You can contact me for additional information.

Jerry Miille
Miille Applied Research Co., Inc.
Houston, Texas
http://www.miille.com

 

Dear Macário,

The Danload 6000 is very bad for communication. Sorry, but you have a great problem.

Bob!