Control

Double Tag Definition error while mapping ACM11 card of Yokogawa Centum CS DCS

M

Thread Starter

Mihir Ramkrishna

We have PLC communicating with YOKOGAWA CENTUM CS DCS through ACM11 card using RS232C link. At present, we have two cards in the AMN33 nest connected to the PLC. In one card we have the mapping of DI defined and while in the other card the definition has been left blank.

We have found out that we have ZACMDUAL software loaded in the system which is responsible for redundant communication. We tried out same mapping in the adjoining ACM11 card but we got double tag definition error.

We would like to know what type of definition has to be configured for the ACM card to eliminate the error and achieve the redundant communication between the PLC and DCS

Please help
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
W Single Flow Double Pressure vs Single Pressure Double Flow Steam Turbines Power Generation 0
N High Cycle Double Dump Valves Control Valves 0
H DCS Alarms & Pump signal double question!! Instrumentation & Measurement 4
K How to convert modbus 8byte hex to double Modbus 28
F Active-X Modbus That Supports Double Floating Point (64bits) Modbus 2
Similar threads
Single Flow Double Pressure vs Single Pressure Double Flow Steam Turbines
High Cycle Double Dump Valves
DCS Alarms & Pump signal double question!!
How to convert modbus 8byte hex to double
Active-X Modbus That Supports Double Floating Point (64bits)

You May Also Like

Top