R
I have purchased 2 PLCs like this with a lot of modules and a PP-0110 programmer for only 100$Can, they where all new in their boxes.
I Would like to interface it to my PC, is it possible? Does somebody know the communication protocol between the PE-0120 and PE-0121, this could be use at least for monitoring?
Any information about that very old PLC would be grately appreciated. I just use this unit to control my furnace, thermo-pump and the dampers in the house for air control. I do not want to invest in a modern PLC, so please do not suggest it.
My main problems are TIME OUT because of power outage(even just 0.5 second), the consuming time for program modifications with the little programming unit and finally the impossibility to easily monitor the overall conditions of operation from far....
Thank you fro your time,
Rej
I Would like to interface it to my PC, is it possible? Does somebody know the communication protocol between the PE-0120 and PE-0121, this could be use at least for monitoring?
Any information about that very old PLC would be grately appreciated. I just use this unit to control my furnace, thermo-pump and the dampers in the house for air control. I do not want to invest in a modern PLC, so please do not suggest it.
My main problems are TIME OUT because of power outage(even just 0.5 second), the consuming time for program modifications with the little programming unit and finally the impossibility to easily monitor the overall conditions of operation from far....
Thank you fro your time,
Rej
