Control

Hello colleague,

S

Thread Starter

Saken

I have some problem with connection between control (operator) and electric actuator Rotork . Serial num: CH32480202 / IQ3/ IQ20
I need connection?
- Command: Open, Close, Stop?
- Opened, Closed, Alarm?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Radu Hello ! With what software could I put the program in this plc and what adapter would I need to connect? General Automation Chat 4
E Hello i have a problem with my Open Fired Furnace need help ! Sensors & Calibration 0
H Hello, I am an Electrical Engineer. I started my career in oil and gas as an instrument engineer. Kindly guide from where I can learn from basic. Instrumentation & Measurement 7
Nabil shayal Hello, I have a problem in CS3000. I want to download a project from HIS0164 - EWS to HIS0155 - OWS. Error message No. 513 appears in HIS0155 Human Machine Interface - HMI 1
R Hello everyone, can you pleases share the PLC software of RsLogix 500? General Automation Chat 1
Similar threads
Hello ! With what software could I put the program in this plc and what adapter would I need to connect?
Hello i have a problem with my Open Fired Furnace need help !
Hello, I am an Electrical Engineer. I started my career in oil and gas as an instrument engineer. Kindly guide from where I can learn from basic.
Hello, I have a problem in CS3000. I want to download a project from HIS0164 - EWS to HIS0155 - OWS. Error message No. 513 appears in HIS0155
Hello everyone, can you pleases share the PLC software of RsLogix 500?

You May Also Like

Top