R
We have Honeywell's TPS for Boiler Controls in Plant. We have the following Nodes on LCN: Four GUS, HM, Primary and Redundant NIMs.
GUS 02's LCN Overview shows HM is "Isol". From other GUS Nodes the LCN view is ok... It's only from GUS02 that we are getting this message. Subsequently, we are even unable to navigate thru LCN Diag, etc. from GUS 02 node.
We tried the following from GUS02:
1) Rebooted the PC... No change.
2) Clicked on "Load Isol" target of the Native Window. It flashes the message "Incompatible State"...
The problem persists still. Can anyone help please?
au revoir
Rahul
GUS 02's LCN Overview shows HM is "Isol". From other GUS Nodes the LCN view is ok... It's only from GUS02 that we are getting this message. Subsequently, we are even unable to navigate thru LCN Diag, etc. from GUS 02 node.
We tried the following from GUS02:
1) Rebooted the PC... No change.
2) Clicked on "Load Isol" target of the Native Window. It flashes the message "Incompatible State"...
The problem persists still. Can anyone help please?
au revoir
Rahul