Mitsubishi Comm's


Thread Starter


It was recommended to use the 71uc24-r24 card in the A1S and an 485-adp at the FX end. Having been through the manuals I made an enquiry with our local Mitsubishi support. Advised to use no protocol mode and write my own (protocol). No examples were forth-comming...Has anyone done this successfully? If yes, could you help me out with an example.

Sari Rantawi

could you please send me the Data Cable pin out for the Converter ( PLC/PC ) rs232/rs422.

I am using Mitsu's Q3A, for what i ve learnt, the sc09 cable consists of a electronics board at the port to CPU. Unlike serial cable used by other PLC which can be made easily.