Control

Omni 6000 and GE WorkstationST

K

Thread Starter

Keran

Good day,

Trying to set up modbus serial link between Omni 6000 Flow Computer and GE WorkstationST. All parameters have been configured on GE machine however still unable to read data from Omni Floating Point Register (32 Bit Floating Point Register 7105). Any suggestions?
 
ControlsGuy25

ControlsGuy25

Keran said:
Good day,

Trying to set up modbus serial link between Omni 6000 Flow Computer and GE WorkstationST. All parameters have been configured on GE machine however still unable to read data from Omni Floating Point Register (32 Bit Floating Point Register 7105). Any suggestions?
Click to expand...
Hi
Would you tell us, hat have been achieved steps by steps till now...
So We may/can have better overview to guide you in a good manner..
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Ahmed Mowns communication between omni FC 6000 and Siemens PLC s7-300 (PN) Modbus 7
P Communication Delay Between Omni-6000 Flow Computer and IC95CMM004 General Communications Chat 0
M Modbus comms from a Omni Flow Computer 6000 Modbus 3
K OMNI 6000 and HMI Communication Human Machine Interface - HMI 1
V Communication between Omni Flow Computer 6000 and Honeywell TDC-3000 General Communications Chat 2
Similar threads
communication between omni FC 6000 and Siemens PLC s7-300 (PN)
Communication Delay Between Omni-6000 Flow Computer and IC95CMM004
Modbus comms from a Omni Flow Computer 6000
OMNI 6000 and HMI Communication
Communication between Omni Flow Computer 6000 and Honeywell TDC-3000

You May Also Like

Top