Control

Problem changing speed with ATV31 and CANbus

A

Thread Starter

Andrew

I'd like to change the speed of the ATV31 while in motion using CANbus and an ATV71 with Controller Inside (acting as CAN master) programmed through Codesys, but when I try to do so (I write the parameter TargetVelocity) the drive stops and I have to set it in motion again. Is there any way to solve this?

Cheers,
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R Problem with thrust measurement - Bently 3300 XL Instrumentation & Measurement 0
zhenpingd45 Problem of oyostepper stepper motors connection Modbus 0
N MARK-V unwanted Logic forcing problem Programmable Logic Controller - PLC 4
S Mark V Simplex logic forcing problem Power Generation 4
H Problem in changing Fuel Metering Valve change in Mark Vie control system Power Generation 1
Similar threads
Problem with thrust measurement - Bently 3300 XL
Problem of oyostepper stepper motors connection
MARK-V unwanted Logic forcing problem
Mark V Simplex logic forcing problem
Problem in changing Fuel Metering Valve change in Mark Vie control system

You May Also Like

Top