Control

Problem of punctures in corona treater rolls

A

Anonymous

Probable reasons:

- Quality of rubber;

- Alignment of steel roller and rubber roller surface;

- Foreign particles on either steel roller or rubber roller surfaces;

- Faulty/warped electrodes.....
 
A

Ami Polymer Pvt. Ltd.

Dear sir,

The reason for puncture in Corona treater roll is that the rubber quality is low. Please contact us for Silicone Rubber sleeves. We are manufacturers of Corona treater Silicone sleeves in India. We supply our sleeves to many manufacturers & suppliers of Corona treaters in India & overseas. These sleeves are manufactured with high grade silicone rubber. Please feel free to contact us.

Regards,
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R Problem with thrust measurement - Bently 3300 XL Instrumentation & Measurement 0
zhenpingd45 Problem of oyostepper stepper motors connection Modbus 0
N MARK-V unwanted Logic forcing problem Programmable Logic Controller - PLC 4
S Mark V Simplex logic forcing problem Power Generation 4
K Problem to Solve General Automation Chat 0
Similar threads
Problem with thrust measurement - Bently 3300 XL
Problem of oyostepper stepper motors connection
MARK-V unwanted Logic forcing problem
Mark V Simplex logic forcing problem
Problem to Solve

You May Also Like

Top