Control.com

Quantum DDO Timeout State

Search Forums New Posts
A

Thread Starter

Asha

I am currently using a DDO module with Quantum PLC in UnityPro. I have two ways of addressing i.e. either %Q [Topological address] or %M [Direct addressing].

Can I use the Topological address when Timeout state for DDO module is set as User defined say 32762 value?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
G Snieder electric tsx quantum Programmable Logic Controller - PLC 2
Chinawenshi Quantum reads M340 data normally, but writes to M340 data jumps, how to solve it? Programmable Logic Controller - PLC 0
Chinawenshi Quantum reads M340 data normally, but writes to M340 data jumps, how to solve it? Distributed Control Systems - DCS 0
E Modicon Quantum: Remote I/O Rack Problem (IOs communication or Drop-out) Programmable Logic Controller - PLC 0
T Modicon Quantum Memory Usage Programmable Logic Controller - PLC 0
Similar threads
Snieder electric tsx quantum
Quantum reads M340 data normally, but writes to M340 data jumps, how to solve it?
Quantum reads M340 data normally, but writes to M340 data jumps, how to solve it?
Modicon Quantum: Remote I/O Rack Problem (IOs communication or Drop-out)
Modicon Quantum Memory Usage

You May Also Like

Top