Control

Sending Data to WinCC database

K

Thread Starter

Keivan Kianfar

I Would Like to send data into the WinCC database (For example, Draw a line in Graphic designer) using C++ or VB6 or VB Net, but I'm unable to find information about the database format and protocol to use.
Thanks

k1succesman [at] gmail.com
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D Modbus newbie: Sending Data Over Modbus from Linux Modbus 1
T Error Sending/Receiving HART commands (SFB52/53): "Faulty, Without Data" General Communications Chat 2
I Sending Data Thru Modbus Between Triconex & C300 Honeywell DCS Distributed Control Systems - DCS 3
A Sending data from two controllers to HMI Programmable Logic Controller - PLC 1
B problem with sending data in serial communication General Communications Chat 0
Similar threads
Modbus newbie: Sending Data Over Modbus from Linux
Error Sending/Receiving HART commands (SFB52/53): "Faulty, Without Data"
Sending Data Thru Modbus Between Triconex & C300 Honeywell DCS
Sending data from two controllers to HMI
problem with sending data in serial communication

You May Also Like

Top