Control

Woodward Governor Control 505

G

Thread Starter

Gopal

We have Woodward 505 installed for a compressor turbide drive control where it switches back to local control from remote. Can anybody explain under what conditions the control switches to local mode?
 
A

ali

Only from key pad you changed its control, remote to local or local to remote. There is only one more reason that there is some break in your signal from DCS to governor.
 
R

Rodolfo Misoczki

Maybe, there are any input contact configured like Remote SetPoint enable. Verify this information trough the IHM. Normally, there are anu CCC or other controller send the set point to W505, then verify this interconections...
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Woodward 505 Governor Details Power Generation 1
M woodward EGB governor with 723plus Power Generation 1
J Woodward Governor Servo Position Controllers Power Generation 2
A Woodward 505 Governor did not switch over during grid failure Power Generation 1
S Woodward Governor Control Optrend HMI Human Machine Interface - HMI 0
Similar threads
Woodward 505 Governor Details
woodward EGB governor with 723plus
Woodward Governor Servo Position Controllers
Woodward 505 Governor did not switch over during grid failure
Woodward Governor Control Optrend HMI

You May Also Like

Top