Hi Guys,
I have a vortex flow meter installed on a oil flow pipeline. The flow meter sometimes read the flow rate but incorrectly and sometimes does not read at all even though there is actual flow in the pipe.
The application is oil flowing through the pipe.
What I have done so far is as follow
1. Inspected buff body for any harden oil.
2. Changed position of flow meter from vertical to horizontal.
3.Replaced flowmeter.
None of these seemed to have worked.
There is also another vortex flowmeter upstream which reads the flow correctly.
Also when we flush the line with water, the flowmeter does not read at all, where as the other flowmeters will read a flowrate of the same type
Is there any setting or config that I can look at with this istrument ?
I have a vortex flow meter installed on a oil flow pipeline. The flow meter sometimes read the flow rate but incorrectly and sometimes does not read at all even though there is actual flow in the pipe.
The application is oil flowing through the pipe.
What I have done so far is as follow
1. Inspected buff body for any harden oil.
2. Changed position of flow meter from vertical to horizontal.
3.Replaced flowmeter.
None of these seemed to have worked.
There is also another vortex flowmeter upstream which reads the flow correctly.
Also when we flush the line with water, the flowmeter does not read at all, where as the other flowmeters will read a flowrate of the same type
Is there any setting or config that I can look at with this istrument ?