Search results

Can you reply to my posts ....thx

I am sayin tha PMS can be not well setted for frequency control mode..

What is OEM Genset Governor Controller ..... ARE YOU SURE ABOUT Droop settings on all gensets

1.2 Droop mode Droop refers to changing the speed and frequency of the generator to proportionally change the load. That is, when the load of the generator increases, the speed or frequency is reduced by simple load feedback. When the generator is running at full load, the Droop mode can...

There should be a difference as you stated on your post that when islanding all is ok only when gensets are " on -grid" that you got frequency excursion so if you can provide what kind of droop curve scheme has been implemented tehn we can guide you better. See some notes : The so-called droop...

Thanks for the imputs /feedback ! All the best Any time!

Maybe load sharing scheme is not tuned properly .. Search for event trigger SOE event list alarms messages if available it should withc Cimplicity.. Also look at the block diagram for Load sharing and droop mode configuration and check if all settings are according to your installation... You...

Hi. Great to hear that problem resolved... Thank you for your reply and sharing these inputs

The gensets should actually work with load sharing scheme.. This is not actually well tuned.. At your yacht... Try to search on PMS datas and post them here so we can be better support..

What H&H stand for in the loab balance sheet .. Thx for sharing again ! we may find the right solution! But not know PF and KVARS values would be difficult to go forward....Yes you may find it at least on PMS datas ...

Looks like HVAC is a big consumer ...

Do the installation use KVM (Keyboard video monitor ) extender With a good topology/architecture drwaing one can try to support remotely!

Hi What is the LEAK TEST PLC stand for... Where are you stuck....

One more thing one should read Bently not "BENTLEY" i dont think that you are talking about car..

Whitout knowing topology architecture of the Monitoring controls systems that will be impossible to guide you as best as we can from here...

Do you got & if yes ... have checked such following module 500/94M VGA DisplayMonitor Module...status

How about the VGA port (I/O) status can you tell us the color ..analog red blue /green sync data or not..

Check the system event list messages see if module detected a internal fault... Also did you managed to connect PC/HOST to the Module by the gateway communication interface..

Thank you

Okay sorry i did not notice that you already mentionned it on th eprevious post ... As i am tryin to support various posters here.. Will be on the look out for these PIDS then we can have a better discussion/overview