Analog Forcing on Mark-VI Simulator


Thread Starter



While I was working on a Mark-vi simulator (the one that simulates operation of a Fr-7FA GTG), I am unable to force analog signals, but forcing logic signals is okay. Another peculiar problem I am facing with this simulator is that when I add an alarm signal in toolbox and configure the same to HMI, all the controls signals on Operator screen (control.cim) behaves erratic. Unable to start the unit, as EOP test run fails and also the FSR GAG automatically changes to Zero etc... I have to reload the entire simulation program to make this work again.

Could some one address this issue please.