Can anyone help me by provoiding Pinouts of programming cable for Modicon compact CPU? I want to communicate built-in Modbus (MB1, RJ 45) of compact cpu with com port on laptop fopr programming via Concept 2.6.

 

From 984-A120 Compact PLC’s User Guide 890 USE 108 00 Version 4.0 Page 72-73 (after some massage)

==E984-258/265/275/285
Connector Pinouts
(RJ45)
The following table describes the connector pinouts of the RJ45 connector.
Signal Name Pinout
+5VDC (150ma Limit) 1
DSR 2
TXD 3
RXD 4
GND 5
*RTS 6 Jumpered
*CTS 7 Jumpered
Chassis Ground 8

*The Modbus 2 port supports neither CTS nor RTS.
==

Meir

 

I have schnieder plc pc E984-265, it have firmware file, ctsxv200.bin. which have been corrupted, pls share me this bin file

 

I have schnieder plc pc E984-265, it have firmware file, ctsxv200.bin. which have been corrupted, pls share me this bin file

May I ask what configuration software your Schneider plc pc E984-265 uses, and which version of windows operating system does the configuration software run on?