B
I am currently trying out this module for hydraulic servo control. I can not
get the channel I'm using for feedback recognize any of the counts. When I set the axis to "feedback only" I get a feedback fault. When I set it to servo, the fault goes away but I do not see any counts in the correct address locations
(or anywhere). Why do I get this feedback fault? Im using a 4x encoder, channels A and B with common tied to the A- and B-. Is there anything special I have to do in the software to read these raw counts? I have it scaled and tried
the GSV instruction as well. Can't currently get through to tech support!
get the channel I'm using for feedback recognize any of the counts. When I set the axis to "feedback only" I get a feedback fault. When I set it to servo, the fault goes away but I do not see any counts in the correct address locations
(or anywhere). Why do I get this feedback fault? Im using a 4x encoder, channels A and B with common tied to the A- and B-. Is there anything special I have to do in the software to read these raw counts? I have it scaled and tried
the GSV instruction as well. Can't currently get through to tech support!