Control.com

CV value displayed on HMI of Gas Turbine

Search Forums New Posts
O

Thread Starter

Operator

CV value displayed on HMI of GT. What is the importance of it for Operator? Any help? For Operator Demand is important. Please advise
Thanks in advance
 
CSA

CSA

Can you please describe the manufacturer and type of the turbine you are operating?

Is the CV value changing during operation?
 
O

Oprator

> Can you please describe the manufacturer and type of the turbine you are operating?

> Is the CV value changing during operation?

Yes On Westinghouse GT W501F
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R How to read 32bit swap floating point value from energy meter in Vijeo Citect 7.5 Modbus 2
Kautsar Wira FRENIC MULTI FRN0.7 VALUE CANNOT CHANGE Programmable Logic Controller - PLC 4
U Increasing or instable Value of GCV for Frame 9E gas turbine on MARK VI system Control Valves 2
K HONEYWELL ENRAF 854 ATG - Initialization value 999999999 Instrumentation & Measurement 6
D In RSLogix 500 PID instruction how can I reset the control value during operation Programmable Logic Controller - PLC 0
Similar threads
How to read 32bit swap floating point value from energy meter in Vijeo Citect 7.5
FRENIC MULTI FRN0.7 VALUE CANNOT CHANGE
Increasing or instable Value of GCV for Frame 9E gas turbine on MARK VI system
HONEYWELL ENRAF 854 ATG - Initialization value 999999999
In RSLogix 500 PID instruction how can I reset the control value during operation

You May Also Like

Top