Hello everyone,
Right now i'm dealing with the project of D652 Steam Turbine and it's single shaft with GT 9HA.02. Due to after this project I will operate the plant. All I want to ask is, the detail for D652 ST start up. From my previous plant, there is Sliding and Fixed Pressure mode during start-up Steam Turbine, but I don't have any experience for GE's machine. Does that mode also applied on GE's Steam Turbine?
I appreciate if you could attach startup curve containing this parameter:
- Steam Pressure
- Steam Temperature
- ST Speed
- Bypass Valve Position (HP, IP & LP)
- ST Load (if any)
btw, I used Mark Vie.
Thank you so much.
regards,
Right now i'm dealing with the project of D652 Steam Turbine and it's single shaft with GT 9HA.02. Due to after this project I will operate the plant. All I want to ask is, the detail for D652 ST start up. From my previous plant, there is Sliding and Fixed Pressure mode during start-up Steam Turbine, but I don't have any experience for GE's machine. Does that mode also applied on GE's Steam Turbine?
I appreciate if you could attach startup curve containing this parameter:
- Steam Pressure
- Steam Temperature
- ST Speed
- Bypass Valve Position (HP, IP & LP)
- ST Load (if any)
btw, I used Mark Vie.
Thank you so much.
regards,