DTM browser on Schneider M-580 not reading more than one request.

I am trying to connect to a Siemens S-1500 PLC over MODBUS TCP via DTM browser. I have more than 125 registers to read. So I have created three requests for the same. I am facing this problem that I am getting data only on one request at a time.
Please suggest a solution for this problem. Thank you.
 
I am trying to connect to a Siemens S-1500 PLC over MODBUS TCP via DTM browser. I have more than 125 registers to read. So I have created three requests for the same. I am facing this problem that I am getting data only on one request at a time.
Please suggest a solution for this problem. Thank you.
Can you tell us if how you get that configuration setted...

Here is a demo on how to get that configuration correct on DTM Browser...

Please do not hesitate to share your inputs!

Glad to support here!

James
 
Or at least can you tell us what have you done till you get that result...

How about TIA portal /win cc configuration is that ok...

Can you share here topology/architecture of the control system... You may nerd to reconfigure it also..
 
Top