Control

How to maintain speed for GT Frame 9E

S

Thread Starter

sonicjoe_xx

Hi,

Our GT is Frame 9E. We are using TMR Mark V <I>.

We wish to test generator vibration level at 97% speed. How do we maintain the speed in Mark V?
Thanks.
 
C

CSA

Most Speedtronic turbine control systems will allow the operator to adjust speed between 95% and 107% *when the generator breaker is open.* (When the generator breaker is closed, the speed of the unit is determined by the frequency of the grid to which the unit is connected.)

So, with your generator breaker open use the LOWER SPD/LOAD button/target to reduce the speed to 97%.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
KunalKumar How to Maintain Starting Diesel Engine for Frame 5 GE gas turbine Power Generation 3
Amanat Hossain GE-9fa DC emergency seal oil pump failed to maintain H2 seal oil DP also same pump is not developing discharge pressure more then 80 psi Power Generation 0
S why should maintain steam drum level 50% Power Generation 3
S To maintain constant frequency on all drives during grid disturbances Power Generation 0
K How to measure and maintain rotating tank level Process Control 4
Similar threads
How to Maintain Starting Diesel Engine for Frame 5 GE gas turbine
GE-9fa DC emergency seal oil pump failed to maintain H2 seal oil DP also same pump is not developing discharge pressure more then 80 psi
why should maintain steam drum level 50%
To maintain constant frequency on all drives during grid disturbances
How to measure and maintain rotating tank level

You May Also Like

Top