Control.com

How to measure vibration in mm/s WHILE Bently Nevada has output of 0-10V?

Search Forums New Posts
E

Thread Starter

engr.Ahmed_Raza

Hey Folk,

I hope you all are good I have a question for you.

We have a motor 3.55MW and and we place a vibration transmitter the alarm and trip point are in mircomili p-p and we want mm/s but the bently nevada output is volt how can we convert this into mm/s?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
O Using Voltage and Current Transducer, Want to measure Power and phase angle Sensors & Calibration 1
C How to measure very low RPM shaft speed? Sensors & Calibration 1
I Level Transmitter to Measure the level of Wastewater in a Sump Tank Instrumentation & Measurement 3
H What device shall i use to measure 400V Voltage which can change frequency between 10-200hz? Instrumentation & Measurement 14
H Pressure sensor to measure frequency conversion water pumps Instrumentation & Measurement 3
Similar threads
Using Voltage and Current Transducer, Want to measure Power and phase angle
How to measure very low RPM shaft speed?
Level Transmitter to Measure the level of Wastewater in a Sump Tank
What device shall i use to measure 400V Voltage which can change frequency between 10-200hz?
Pressure sensor to measure frequency conversion water pumps

You May Also Like

Top