B
I believe some of the default settings are 9600 baud, 8 data bits, 1 stop bit and no parity. However, I can't figure out if it should be RS-422, RS-485 2-wire or 4-wire. Does anyone know what these settings would be?
Is Modbus communication even enabled before an IR tech configures Modbus? I'm sure that if I had an IR tech come out, I could just have him set it to whatever I want.
Is Modbus communication even enabled before an IR tech configures Modbus? I'm sure that if I had an IR tech come out, I could just have him set it to whatever I want.