Looking for service and user manual on the Altivar 5 Serie 45 2.

At startup of motor I get the indication OcF (Over current) yet we only physically moved the machine and controller. I assume the electricians made an error in hooking it back or a sensor might block the unit. For that reason I would like to find a manual.

Any help more than welcome.

Thanks

Cheers

 

The Altivar drives are a SquareD product. (Same group: Schneider/Telemechanique/Merlin Gerin/SquareD) I recently downloaded the manual for an Altivar 11 from
http://www.squared.com/

I checked there but couldn't find the one you are after so you may have to use their contact details and get them to e-mail one.

Vince

 

Danny,

Prior to energizing motor controller, how was direction of rotation
checked?

Regards,
Phil Corso, PE
Boca Raton, FL
[[email protected]] ([email protected]) {[email protected]}

 

This product was already fail out in 1993 (I work for schneider before). but you can contact Schneider France, http://www.schneider-electric.com

I give you another suggestion. You can replace it by atv66/or atv58 if not supported. It's very easy.

Have a nice day!

 

I have the printed Manual for the altivar 5. Please tell me what is yor e-mail address and I will send you the most important pages (digitalized)

Bye

Jose

 

Hello Jose,

I am a New Zealand engineer currently working in Northern Ireland. I too require the set-up details for an Altivar 5. Any chance of you sending me a copy?

Any help would be much appreciated.

Kind Regards
Edward

 

Hello,

I have the Altivar 5 manual. I can make it available to download on my website if requested. I normally repalce this old inverter with a Yaskawa.

Hope this helps.

Goto http:\\www.iesgso.com and put in a request for literature and I will put it up.

Ken