C
Hello,
This is my first post on Control.com. We have a GE Mark V system with only R and C processors (which I believe is considered a 'simplex' system).
Every once in a while the communications disappear on the HMI and we have to reset the C processor by performing the following steps: Clear the error messages, turn off the C processor, wait so many seconds then turn the C processor back on. The HMI indicates the turbine has tripped and needs to be reset.
Has anyone had similar experiences with a Mark V C processor intermittently needing a reboot and what would cause the C processor to suddenly stop? Where would the error messages that pre-date the locking(?) of the C processor be found in the HMI directory?
I am new to the Mark V and I am just now working my way deeper into the innards of this thing.
Any help would be very much appreciated.
This is my first post on Control.com. We have a GE Mark V system with only R and C processors (which I believe is considered a 'simplex' system).
Every once in a while the communications disappear on the HMI and we have to reset the C processor by performing the following steps: Clear the error messages, turn off the C processor, wait so many seconds then turn the C processor back on. The HMI indicates the turbine has tripped and needs to be reset.
Has anyone had similar experiences with a Mark V C processor intermittently needing a reboot and what would cause the C processor to suddenly stop? Where would the error messages that pre-date the locking(?) of the C processor be found in the HMI directory?
I am new to the Mark V and I am just now working my way deeper into the innards of this thing.
Any help would be very much appreciated.