M
We tried to maintain communication between Siemens S5 PLC and Emerson DCS (Provox) via ModBus RTU but there was no success.
The parameters were as follows:
- baudrate "19200"
- parity "Even"
- stop bit "1"
- number of data bits "8"
I know that if simatic S7 PLC were used instead of S5 there was not such a problem. Pls. advise is that actually possible to maintain such Modbus communication between S5 PLC and DCS or is there anybody who has done it?
Thanks
M.Movahedan
The parameters were as follows:
- baudrate "19200"
- parity "Even"
- stop bit "1"
- number of data bits "8"
I know that if simatic S7 PLC were used instead of S5 there was not such a problem. Pls. advise is that actually possible to maintain such Modbus communication between S5 PLC and DCS or is there anybody who has done it?
Thanks
M.Movahedan