Power Generator Cannot Sync in Remote

Dear All,
We have a Power generator that cannot remote sync.It has the following fault on CitectSCADA 2015-"Another Sync Channel Has Been Selected"
Citect is reading off a PLC register R00007 and comments says;"Sync panel 1 selection feedback-DI Register".Ge PLC reads off a ABB Synchrotact 5.What input or output in the ABB Synchrotact 5 is generating this alarm or what causing this alarm to pop-up on CitectSCADA?
Thank you
 
Dear All,
We have a Power generator that cannot remote sync.It has the following fault on CitectSCADA 2015-"Another Sync Channel Has Been Selected"
Citect is reading off a PLC register R00007 and comments says;"Sync panel 1 selection feedback-DI Register".Ge PLC reads off a ABB Synchrotact 5.What input or output in the ABB Synchrotact 5 is generating this alarm or what causing this alarm to pop-up on CitectSCADA?
Thank you
Hello

Without be able to check the wiring diagram or interconnecting diagrams , it is difficult to give you an answer..
Each site got is own as built drawings !

James
 
Top